'EVE-NG QEMU based nodes are not starting
Setup:Dell PowerEdge R620 128GB Ram 12 Core server. Vmware ESXI 6.5 Based setup: 1 VM for EVE-NG: 500GB SSD + 32 GB allocated RAM. 2nd VM for Windows Server 2016: 100GB HDD + 16 GB RAM. On Windows client, I can access the EVE-NG via Firefox and Putty. I have tried cisco Dynamips images and nodes are starting (I can telnet with putty and change config)
When I try to created nodes based on Qemu Images(Cisco, Aruba, Paloalto, etc), the nodes do not start. I have followed the guidelines for qcow2 names as well as checked multiple sources. I have also edited the node and tried to play with all possible settings. I have reinstalled the EVE-NG on ESXi as well but the issue remains the same.
Thanks a lot for your help and support.
Solution 1:[1]
On CPU Settings on Set "Enable Virtualized CPU Performance Counter"
Solution 2:[2]
I finally found an answer in the EVE-NG cookbook: https://www.eve-ng.net/wp-content/uploads/2020/06/EVE-Comm-BOOK-1.09-2020.pdf Page33: Step 6: IMPORTANT Open VM Settings. Set the quantity of CPUs and number of cores per socket. Set Intel VT-x/EPT. Hardware Virtualization engine to ON (checked). Once I checked this field, all nodes are started to work.
Sources
This article follows the attribution requirements of Stack Overflow and is licensed under CC BY-SA 3.0.
Source: Stack Overflow
| Solution | Source |
|---|---|
| Solution 1 | Jean Fredson |
| Solution 2 | Heinreich213 |