'standby command on cisco 3650-24ps not found packet tracer
I'm currently trying to build a small network with two 3650-24ps Multilayer switches at the distribution level in packet tracer. I want to enable HSRP and configure a virtual default gateway interface at 172.16.100.1 for both Multilayer switches but when I enter the interface on one of the Multilayer switches and type "standby ?" it says "% Unrecognized command". I looked up a tutorial video and the person is using the same 3650-24ps Multilayer switch but on his switch the command is working. What do I need to do to get the standby command on my 3650-24ps Multilayer switch?
Solution 1:[1]
would be good to see what you have already configured in the packet tracer. where do you run this standby command, you know you have to run it on a vlan interface and not a physical interface ?
Also packet tracer is not really a suitable app to use for training. Consider using GNS3.
Sources
This article follows the attribution requirements of Stack Overflow and is licensed under CC BY-SA 3.0.
Source: Stack Overflow
| Solution | Source |
|---|---|
| Solution 1 | Max |